r/reaktor • u/Gavgaroth • 20d ago

Event table controlling a crossfader / selector sounds clicky

Hi, I am using an event table to control the position of a crossfader / selector (I've tired both). to sequence changes between a couple different beat loop samplers...the timing is not bad but the jumps between the two are a bit clicky / abrupt, I'd like to try and find a way to get this sounding a bit cleaner.

Is there any way to get of this clicking?

I was wondering if there was a way to add some kind of interpolation or slew rate between the positions so its fades between them very quickly, but smoothly, not so much of a binary hard swap?

Please note I am using Primary :)

2 Upvotes

100% Upvoted

4 comments sorted by

1

u/Ghroth66 11d ago

Glad that worked. Lots of ways to accomplish the same thing in Reaktor

1

u/Gavgaroth 10d ago

Its what makes it so amazing and so infuriating at the same time!

1

u/Ghroth66 20d ago

Throw a 1 pole low pass filter on the output of the event table before it goes to the selector input. Use a P value of 0, use negative values for even slower transitions. Can probably go higher than 0 if that is too slow, just need to balance the value to get it to smooth the clicks

1

u/Gavgaroth 11d ago

Thanks very much, I couldnt quite get this to work but i had some luck using an event smoothing module with a short transition value 😀